TICKET HOLDER
TICKET HOLDER
The Ticket Holder can about from making tags with my Stamped Tissue Paper.
The starting point is some covered Tags.
My Tag size was determined by the card I was using up. 7 and a half by 3 three quarters.
Then trim the corners too – your taste.
Cover with book pages or Encyclopedia Pages. The result will show through the tissue to add colour.
Glued with Tacky PVA
The tissue was cut bigger than the tag to allow for crinkles etc. Then trimmed it can be folded over to cover the back if you want.
Glue stick for this as wet glue with make the ink run.
Check the edges incase there’s any loose paper.
Fold over the top inch of the tag to create the closing on the tag. keeping this closed, fold the rest in half , leaving a little space at the top.
Ink at this stage if you want both sides.
I used Distress Soot Black
Choose that paper to create the pockets for the tickets. I used Tim Holtz Collage 8X8.
Cut two small strips, slightly smaller than the width of your holder . 1 and a half x 2 and a half.
I rounded the corners on the bottom side only and cut the notches. Ink if required.
Stick on the bottom and the fold of the Tag leaving a little space all round the pocket.
The Front Cover Pocket using the same paper is 2 inches by 3 inches with rounded corners at the bottom and cut the notch.
I stamped on a piece of the same card TICKET and stick it centrally on to this.
The hole for the tag is now covered with a bit of paper from the chosen paper.
The Front Cover Pocket using the same paper is 2 inches by 3 inches with rounded corners at the bottom and cut the notch.
I stamped on a piece of the same card TICKET and stick it centrally on to this.
Add your tickets – Ticket Booth but you can use any.
Closure, string wrapped round twice plus and a tiny clip to finish it off.
You can use this folder for anything not just tickets.
Have Fun!
